| Launch date | Make / Model | Concern | Remedy | Build range | Manufacturer ref | Vehicles |
|---|---|---|---|---|---|---|
| 2013-12-03 |
MITSUBISHI - L200
L200
|
FUEL MAY LEAK | Recall the vehicles that are likely to be affected to check and where necessary replace the propeller shaft. | - → - | R30225101112 &13 | 220 |
| 2013-12-03 |
MITSUBISHI - L200
L200
|
VEHICLE MAY BECOME UNSTABLE | Recall the vehicles that are likely to be affected to check and where necessary replace any defective lower suspension arms. | - → - | R30222303132 &33 | 5461 |
| 2013-12-03 |
MITSUBISHI - L200
L200
|
IN EXTREME CASES FIRE MAY OCCUR | Recall the vehicles that are likely to be affected to replace the powered seat recliner levers and where necessary the adjuster assemblies. | - → - | R3021740 4142 43 | 3133 |
| 2013-11-18 |
MITSUBISHI - LANCER EVOLUTION
LANCER EVOLUTION
|
CLUTCH MAY FAIL | Recall the vehicles that are likely to be affected to replace the clutch master cylinder with a modified unit. | - → - | R3022821 | 529 |
| 2013-06-28 |
MITSUBISHI - L200
L200
|
ENGINE MAY STALL | Recall the vehicles that are likely to be affected to re programme the ECU and where necessary replace the air flow sensor. | - → - | 8263 | |
| 2010-08-18 |
MITSUBISHI - LANCER
LANCER
|
CLUTCH MAY FAIL | Recall affected vehicles and replace fixing clip with modified stronger version. | - → - | R3017710 | 9903 |
| 2010-08-18 |
MITSUBISHI - L200
L200
|
TOP SUSPENSION BALL JOINT MAY BECOME DETACHED | Recall affected vehicles to check the torque of the bolts and if required replace the top suspension arm. | - → - | 29750 | |
| 2010-07-01 |
MITSUBISHI - L200
L200
|
REAR PROTECTION BAR MAY DETACH | Recall the affected vehicles and replace the bar with a modified type. | - → - | R3017310 | 590 |
| 2009-12-29 |
MITSUBISHI - LANCER
LANCER
|
FUEL MAY LEAK | Recall the vehicles that are likely to be affected to replace the fuel return pipe for one of a modified type. | - → - | R3017210 | 1384 |
| 2008-12-01 |
MITSUBISHI - L200
L200
|
REAR AXLE MAY BECOME INSECURE | Recalled vehicles will have the rear axle U bolts replaced with quality assured items. | - → - | 20445 | |
| 2008-01-01 |
MITSUBISHI - L300
nicht überwacht | Mögliche Eingrenzung der betroffenen Modelle: N/A | Hotline des Herstellers: 06147207629 | Rückrufseite des Herstellers: N/A | Bekannte Vorfälle mit Sach- und/oder Personenschäden: N/A | Überwachung der Rückrufaktion durch das KBA: nicht
|
Unzureichende Materialstärke an der Schweißnaht am Befestigungshalter des Hauptschalldämpfers könnte zu einem Lösen oder Herunterfallen des Auspuffrohres führen. | 1994-01-01 → 1995-01-01 | ENL-06-SR-003 | 249 | |
| 2008-01-01 |
MITSUBISHI - L200, PAJERO
überwacht | Mögliche Eingrenzung der betroffenen Modelle: N/A | Hotline des Herstellers: 06147207687 | Rückrufseite des Herstellers: N/A | Bekannte Vorfälle mit Sach- und/oder Personenschäden: N/A | Überwachung der Rückrufaktion durch das KBA: überwacht
|
Durch eindringendes Wasser am Kugelgelenk-Lenkungsumlenkhebel und entstehender Korrosion kann der Kugelgelenkbolzen brechen. | 1990-01-01 → 2000-01-01 | ENL-04-SC-003 | 58613 | |
| 2007-05-25 |
MITSUBISHI - L200
L200
|
FUEL MAY LEAK | Recalled vehicles will have the fuel filter water sensor replaced. | - → - | 7917 | |
| 2007-03-14 |
MITSUBISHI - LANCER
LANCER
|
OIL MAY LEAK | Recall affected vehicles and check gap between towing hook and oil cooler hose. If less than 15mm install modified pipe. If more than 15mm check pipe for damage and if necessary replace. | - → - | R3009700 & R3009710 | 3 |
| 2005-09-05 |
MITSUBISHI - L300
L300
|
EXHAUST PIPE COULD FAIL POTENTIALLY RESULTING IN EXCESSIVE NOISE | Recall affected vehicles and check whether the exhaust is original. If this is the case a new exhaust box will be fitted. | 1994-07-01 → 1995-07-01 | 1 | |
| 2004-12-03 |
MITSUBISHI - L200
L200
|
POSSIBILITY THAT THE BONNET SAFETY HOOK IS DEFECTIVE | Likely to be affected vehicles will be recalled at which time the safety hook bracket will be checked for profile and adjusted if necessary. | - → - | 13628 | |
| 2003-10-31 |
MITSUBISHI - LANCER
LANCER
|
INABILITY TO CHANGE GEAR | Check the tightness of the gear shift pin if loose fit a new gear shift set. If the pin is tight a secondary locking arrangement will be fitted as a precaution. | - → - | 575 |