BENTLEY CONTINENTAL 2006 recalls

Recall search results

Launch date Make / Model Concern Remedy Build range Manufacturer ref Vehicles
2013-10-21
BENTLEY MOTORS LIMITED - CONTINENTAL GT
POSSIBLE LOSS OF REAR BRAKE Recall the vehicles that are likely to be affected to replace the affected stainless steel screws with a screw of a different material that is not susceptible to stress corrosion cracking. 2006-07-01 → 2010-06-01 R790 2030329/1 343
2013-10-21
BENTLEY MOTORS LIMITED - CONTINENTAL GTC
POSSIBLE LOSS OF REAR BRAKE Recall the vehicles that are likely to be affected to replace the affected stainless steel screws with a screw of a different material that is not susceptible to stress corrosion cracking. 2006-07-01 → 2010-06-30 R790 2030329/1 343
2013-10-21
BENTLEY MOTORS LIMITED - CONTINENTAL FLYING SPUR
POSSIBLE LOSS OF REAR BRAKE Recall the vehicles that are likely to be affected to replace the affected stainless steel screws with a screw of a different material that is not susceptible to stress corrosion cracking. 2006-07-01 → 2010-06-01 R790 2030329/1 343
2008-05-22
BENTLEY - CONTINENTAL FLYING SPUR, CONTINENTAL GTC, CONTINENTAL GT, CONTINENTAL GT SPEED
Die äußere Oberfläche des Kraftstofffilters korrodiert durch Streusalzeinwirkung. In Extremfällen kann des Filtergehäuse durchlässig werden, was zu einem Kraftstoffleck führen kann. Ein solches Leck birgt ein Brandrisiko. 2003-01-01 → 2008-01-01 N/A 1739
2008-05-14
BENTLEY MOTORS LIMITED - CONTINENTAL FLYING SPUR
FUEL MAY LEAK Recall the affected vehicles to have the fuel filter replaced by the later designed corrosion-resistant coated filter and move the retaining clip. 2003-12-04 → 2008-03-17 RE08/02 7539
2008-05-14
BENTLEY MOTORS LIMITED - CONTINENTAL GT
FUEL MAY LEAK Recall the affected vehicles to have the fuel filter replaced by the later designed corrosion-resistant coated filter and move the retaining clip. 2003-12-04 → 2008-03-18 RE08/02 7539
2006-08-22
BENTLEY MOTORS LIMITED - CONTINENTAL GT
POTENTIAL LOSS OF BRAKING EFFICIENCY Recalled vehicles will be inspected and the clearance between the brake pipe and hose clip checked. If the clearance is to tolerance and no damage exists no further action will be required. Should the clearance be below the required standard remedial action will be taken as appropriate. - → - AGS EJD 536
1997-03-21
BENTLEY MOTORS LIMITED - CONTINENTAL
POSSIBLE FOULING OF BRAKE PIPES The affected vehicles are being recalled for inspection of the hydraulic pipes concerned. Where pipe clearance is found to be insufficient this will be adjusted to accord with the manufacturers specification. - → - 35