| Lanseringsdato | Merke / Modell | Problem | Tiltak | Produksjonsperiode | Produsentreferanse | Kjøretøy |
|---|---|---|---|---|---|---|
| 2018-02-09 |
KAWASAKI - ZX1000S
ZX1000S
|
TRANSMISSION MAY FAIL | On affected machines replace the 2nd 3rd and 4th output gears and the 2nd input gear | - → - | DAH31 | 1064 |
| 2018-02-09 |
KAWASAKI - ZX1000Z
ZX1000Z
|
TRANSMISSION MAY FAIL | On affected machines replace the 2nd 3rd and 4th output gears and the 2nd input gear | - → - | DAH31 | 1064 |
| 2017-11-13 |
KAWASAKI - ZR900BH
ZR900BH
|
THE TIE ROD INSTALLATION BRACKET MAY BREAK | Inspect the frame for damage and fit additional bracing brackets to the frame. In rare cases the frame may need to be replaced. | - → - | DAH34-A | 671 |
| 2017-11-13 |
KAWASAKI - ZR900BJ
ZR900BJ
|
THE TIE ROD INSTALLATION BRACKET MAY BREAK | Inspect the frame for damage and fit additional bracing brackets to the frame. In rare cases the frame may need to be replaced. | - → - | DAH34-A | 671 |
| 2016-02-29 |
KAWASAKI - ZX-10
ZX-10
|
STYRINGEN KAN SVIKTE | Recall the machines that are likely to be affected and replace both bolts with new ones. | - → - | DAG41 | 310 |
| 2013-08-09 |
KAWASAKI - ZR800
ZR800
|
ABS FUNGERER KANSKJE IKKE RIKTIG | Recall the machines that are likely to be affected and replace the ABS unit. | - → - | DAE69 | 50 |
| 2012-08-14 |
KAWASAKI - ZX1000
ZX1000
|
OLJE KAN LEKKE | The repair consists of adding a special sealing compound to the affected area to avoid any possibility of oil leakage. | - → - | DAE13 | 816 |
| 2012-08-08 |
KAWASAKI - ZG1400
ZG1400
|
REAR BRAKE MAY FAIL | The repair consists of replacing the rear master cylinder rod end and removing the guard. | - → - | DAE20 | 1476 |
| 2012-03-02 |
KAWASAKI - ZX-6
ZX-6
|
MOTOREN KAN STOPPE | Recall the machines which are likely to be affected to replace the regulator. | - → - | DAA921A | 3656 |
| 2012-03-02 |
KAWASAKI - ZX-10
ZX-10
|
MOTOREN KAN STOPPE | Recall the machines which are likely to be affected to replace the regulator. | - → - | DAA921A | 3656 |
| 2011-08-02 |
KAWASAKI - ZX-10
ZX-10
|
MOTOREN KAN SVIKTE | Recall vehicles to inspect and re-route harness if harness damaged this will be repaired or replaced. | - → - | DAD60 | 628 |
| 2009-01-19 |
KAWASAKI - ZG1400
ZG1400
|
POSSIBLE LOSS OF CONTROL DUE TO REAR BRAKE LOCK UP. | Recalled machines will be fitted with a brake pedal protective cover. | - → - | DAB800A | 752 |
| 2008-06-20 |
KAWASAKI - ZZ-R1400
überwacht | Mögliche Eingrenzung der betroffenen Modelle: N/A | Hotline des Herstellers: keine | Rückrufseite des Herstellers: N/A | Bekannte Vorfälle mit Sach- und/oder Personenschäden: N/A | Überwachung der Rückrufaktion durch das KBA: überwacht
|
Zu festes Anziehen der Einstellgewinde für die Motoraufhängung kann zur Überlastung der Schweißnaht am unteren Querrohr führen. Bei hoher Belastung des Motorrades kann die Schweißnaht reißen, sich das Querrohr lösen und einen Unfall verursachen. | 2006-01-01 → 2007-01-01 | DAA92 | 1523 | |
| 2008-06-13 |
KAWASAKI - ZX1400B6F
ZX1400B6F
|
SEPARATION OF THE FRAME CROSS PIPE. | Recall the machines that are likely to be affected to check the torque of the engine mounting collars and where necessary retorque them. If the mountings have been over tightened the engine mounting frame will have to be removed for inspection and replaced where necessary. | - → - | 1239 | |
| 2008-06-13 |
KAWASAKI - ZX1400B7F
ZX1400B7F
|
SEPARATION OF THE FRAME CROSS PIPE. | Recall the machines that are likely to be affected to check the torque of the engine mounting collars and where necessary retorque them. If the mountings have been over tightened the engine mounting frame will have to be removed for inspection and replaced where necessary. | - → - | 1239 | |
| 2008-06-13 |
KAWASAKI - ZX1400A7F
ZX1400A7F
|
SEPARATION OF THE FRAME CROSS PIPE. | Recall the machines that are likely to be affected to check the torque of the engine mounting collars and where necessary retorque them. If the mountings have been over tightened the engine mounting frame will have to be removed for inspection and replaced where necessary. | - → - | 1239 | |
| 2008-06-13 |
KAWASAKI - ZX1400A6F
ZX1400A6F
|
SEPARATION OF THE FRAME CROSS PIPE. | Recall the machines that are likely to be affected to check the torque of the engine mounting collars and where necessary retorque them. If the mountings have been over tightened the engine mounting frame will have to be removed for inspection and replaced where necessary. | - → - | 1239 | |
| 2008-02-01 |
KAWASAKI - ZG1400
ZG1400
|
SIDE CASE MAY BECOME DETACHED | Recall the machines that are likely to be affected to replace the locks on both the left and right side cases. | - → - | 397 | |
| 2008-02-01 |
KAWASAKI - ZG1400
ZG1400
|
REAR CARRIER MAY BECOME DETATCHED | Recall the machines that are likely to be affected to replace the luggage rack with one that has been newly designed and reinforced. | - → - | 330 | |
| 2006-10-11 |
KAWASAKI - ZX600E6F
ZX600E6F
|
MOTOREN KAN SVIKTE | Recall the vehicles that are likely to be affected to check the cylinder head Lot number and check the depth of the spark plug. Where the depth of the spark plug is incorrect it will be necessary to replace the cylinder head. | - → - | 190 |